MSI 6741 DRIVER

While doing the installation, be careful in holding the components and follow the installation procedures. Follow the instructions below to clear the data: Memory modules can be installed in any combination as follows: The third PCI slot supports 2 master devices. If you do not find the heat sink and cooling fan, contact your dealer to purchase and install them before turning on the computer.

Uploader: Netaxe
Date Added: 2 November 2007
File Size: 59.3 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 27057
Price: Free* [*Free Regsitration Required]

You can plug the USB device directly into the connector.

MSI Ms K8mm-ilsr Ver 1 Socket Motherboard With BP | eBay

Memory modules can be installed in any combination as follows: Meanwhile, read the documentation for the expansion card to make any necessary hardware or software settings for the expansion card, such as jumpers, switches or BIOS configuration. Then push down the power supply firmly into the connector. You can install either single- or double-sided modules in any order to meet your own needs.

Refer to the hard disk documentation supplied by hard disk vendors for jumper setting instructions. Always consult the vendors for proper CPU cooling fan. Pull the mei sideways away from the socket.

AGP is an interface specification designed for the throughput demands of 3D graphics. Before inserting the power supply connector, always make sure that all components are installed properly to ensure that no damage will be caused.

  AMBIR TECHNOLOGY PS667 DRIVER DOWNLOAD

Overheating Overheating will seriously damage the CPU and system, always make sure the cooling fan can work properly to protect the CPU from overheating. You can clear CMOS by shorting pin while the system is off. Please note that any violation of the correct installation procedures may cause permanent damages to your mainboard. Smi the mainboard has a System Hardware Monitor chipset on-board, you msii use a specially designed fan with speed sensor to take advantage of the CPU fan control.

Each lever can be pressed down in ksi ONE direction.

Hardware Setup Hardware Setup This chapter tells you how to install the CPU, memory modules, and expansion 67441, as well as how to setup the jumpers on the mainboard. IDE1 can connect a Master and a Slave drive. The module will only fit in the right orientation.

MSI K8MM-ILSR – motherboard – micro ATX – Socket – K8M Overview – CNET

Floppy Disk Drive Connector: Follow the instructions below to clear the data: If you do not find the heat sink and cooling fan, contact your dealer to purchase and install them before turning on the computer.

You can attach a serial mouse or other serial devices directly to the 671. Look for the gold arrow.

  LANIER MP C5000/LD550C PCL5C DRIVER DOWNLOAD

You can barely see the golden finger if the module is properly inserted in the socket. Connect the fan power cable from the mounted fan to the 3-pin mssi power connector on the board. The gold arrow should point towards the lever pivot. Please turn off the power and unplug the power cord before installing the CPU.

Also, it provides the instructions on connecting the peripheral devices, such as the mouse, keyboard, etc. Mount the fan on top of the heatsink.

MSI MS-6741 Manuals

Then mei it in until the golden finger on the memory mwi is deeply inserted in the socket. The plastic clip at each side of the DIMM slot will automatically close. It supports a three-pin head connector.

If you install two hard disks on cable, you must configure the second drive to Slave mode by setting its jumper. It introduces a 66MHz, bit channel for the graphics controller to directly access main memory.

While doing the installation, be careful in holding the components and follow the installation procedures.